Hộp Đựng Bài Ma Thuật Nam Châm

Magnetic deck box designed for sleeved 100 card mtg decks. Has plenty for space for tokens. If you have use skinny card divider or no card divider, you can fit 2 toploaders sideways (see third picture).

Needed Parts

8x 6x2mm magnets

Printing Instructions

Print both parts in downloaded orientation. Supports should not be required.

Assembly Instructions

Insert magnets into these holes:

Make sure the magnets are oriented in the same direction on each part, like in the example below. This ensures that the lid will be able to go on either way.

It may be helpful to use some pliers to push magnets into the holes. The holes are designed so the magnets sit just under the surface, so using an extra magnet (like shown below) may help here. I used a Knipex pliers wrench here, but any pliers should work well.

If you are having trouble getting the first magnet to stay in place, you can try using other magnets to hold them in from the other side:

The plastic may creep over time and the magnets may fall out. If that happens, you should be able to use super glue instead of friction to hold them in.