
Khối Lập Phương Chia Đoạn Theo Thông Số
- Downloads
- 4,026
- Likes
- 758
- Views
- 14,197
- Remixes
- 1
- Comments
- 0
Files 8 151.3 MB
- sectioned_cube_WITH_LOGO_1766989656.3mf3MF · 9.3 MB
- sectioned_cube_3X3_1766989657.3mf3MF · 2.8 MB
- sectioned_cube_4X4_1766989658.3mf3MF · 5.5 MB
- sectioned_cube_5X5_1766989659.3mf3MF · 9.1 MB
Make a variant with AI
Build another version of this model.
Remix versions 1
See all 1 remixDetails
- Model ID
- #182399
- Category
- Đồ Chơi Khác
- Published
Description
I tried to make the “sliding section fidget cube thingy” that had a few versions pop up lately… but i wanted it to be parametric.
attached is a FUSION 360 file for you to mess around with and get custom sizes!
NOW IN KEYCHAIN SIZE!
(note the paramaters comments. to change parameters go to: MODIFY>CHANGE PARAMETERS>EXPRESSION)
The print i showed was done with PLA altho i would reccomend PETG since it slides better…
Make sure your bed adhesion and overhangs are on point! you could probobly get away with 0% cooling thanks to the looooooong layer time
--------------------------------------------------------------
P.S
if the sections move with too much friction, a solution i found it to WASH the print in water, while sliding the sections back and forth.
Congratulations to Gunny 3D for winning the 15*15 challange!
Honourable mention goes to Scott Yehle for his print!
Print spec
- Formats
- 3mff3d
- Model files
- 8
- Total size
- 151.3 MB
- Largest file
- 93.8 MB
0 comments
You may also like 12 models
See all-

-

-

-

-

-

-

-
New -

-

-

-



