Mô hình Geared Sith Holocron In 3D

Fully printable Sith holocron. Corners are mechanically linked so they spin together.

Assembly instructions:

1. Print quantities as listed in the file name. I recommend using Prusaslicer's automatic painted supports for the gears.
2. Install gear-2 in each of the 3 body corners
3. Press the 3x gold side triangles onto gear-2
4. Orient gold side triangles so they sit flat against the ground
5. Install gear-1 into the top body half
6. Press the gold top triangle onto gear-1
7. Make sure your corners are aligned! Press the body halves together to link gears
8. Install the bottom body flat to tie the body together
9. Spin the top triangle. You may need to run your gears in a little, but everything should spin together. If not, peel the body open and adjust or add grease
10. Glue the red body and top triangle windows on

You can get some neat translucent effects by using a color swap after 1 or 2 layers on the windows. Play around and have fun.

The multi-color 3mf file is for people who have a multi-color system. It is not necessary to build a holocron.

Also available on Thingiverse