Skip to main content
F3D
Móc/Vòng Treo Bình Nước Siêu Nhẹ Đi Phượt 1

9 images

Thể Thao & Ngoài Trời

Móc/Vòng Treo Bình Nước Siêu Nhẹ Đi Phượt

By MatthewGTaylor

Downloads
106
Likes
74
Views
1,199

Files 3 5.9 MB

  • UL_Water_Bottle_Loop_2A02-5_MatthewGTaylor_1766929900.3mf3MF · 302 KB
  • UL_Water_Bottle_Loop_MatthewGTaylor_1766929901.stlSTL · 920.3 KB
  • UL_Water_Bottle_Loop_2A02-5_MatthewGTaylor_0.6n_0.15mm_PETG_MK3S_1h17m_1766929902.gcodeGCODE · 4.7 MB

Make a variant with AI

Build another version of this model.

Open Studio

Description

Proven on the trail, this is a convenient and lightweight solution for hydration in the outdoors. Great for work or school, too. 

Attaches with a standard zip tie that tucks into a recess to hold it in place and out of the way. 

Hook it to your waistbelt, chest strap or the edge of your pocket if you’re just kicking around town. 

Nalgene bottles are great for car camping or school, but they weigh 175 grams (6 ounces) empty!! That‘s ¾ of a pound of plastic if you’re carrying 2 bottles. Cut that to about 50 grams each with this convenient solution - saving about 250 g (9 ounces) for 2 bottles, that’s a huge savings toward an ultralight kit.

Fits: 

  • Smartwater bottles - 1 liter and 700ml. Works with Sawyer Squeeze filter attached, too. 
  • Bodyarmor - full 1 liter (34 oz), wide mouth bottle with a great shape, a fairly new option and my favorite. Seems a bit more rugged than the Smartwater bottle so far for me. So nice!
  • Powerade and Gatorade bottles with the large mouth - 28 oz and the pre-shrinkflated whole 32 oz quart, ahh the good old days…

Print directions | PETG material suggested. Print with 3 perimeters, .2mm layer height or smaller looks best. Place one flat surface on the bed. Prints clean with no suports required. 

Assembly and care | Use a standard UL type 21S zip tie like these, typically 8" and 50 or 75lb rated. Orient with the loose “tag” end coming through the hole as shown in the detail pic. Use needle nose pliers to pull it firmly for a solid attachment to the bottle that doesn't tilt or rotate. Trim the extra length of the zip tie off with flush cutters. Or if you use wire cutters or scissors, trim it flush with an Xacto or razor blade. 

Recommend hand washing as a hot dishwasher allows the nylon zip tie to stretch a little bit. A tight fit to the bottle is best. 

Other info |

Designed in Autodesk Fusion 360 for personal use.

Printed in Atomic Filament PETG Pro in Olive Drab, Dark Cherry and Khaki.

Read more Show less

Print spec

Formats
3mfgcodestl
Model files
3
Total size
5.9 MB
Largest file
4.7 MB

0 comments

See all