Skip to main content
F3D
Giá để giấy bạc / đồ cuộn nhà bếp dưới gầm kệ 1

1 image

Đồ Gia Dụng

Giá để giấy bạc / đồ cuộn nhà bếp dưới gầm kệ

By GregoryMahan_1528002

Downloads
248
Likes
100
Views
1,528

Files 4 1.1 MB

  • Peg_Make_8_1766911574.stlSTL · 484 B
  • Shelf_Bottom_1766911574.stlSTL · 105.2 KB
  • Shelf_Top_1766911575.stlSTL · 106.7 KB
  • under_shelf_kitchen_foil_holder_1766911576.3mf3MF · 895.5 KB

Make a variant with AI

Build another version of this model.

Open Studio

Description

I've been on an organizing kick lately in my kitchen, and I ran across an under-shelf cling-wrap box holder. But, I didn't much care for it. It printed tall--very tall-- so it takes a bit longer, since printing along the z-axis is slower than along the x-y axis. Tall prints with narrow parts can get a bit shaky, and therefore messy, at the tops of the prints. And worst of all for my OCD, the storage spaces were all different sizes!

So I engineered (over-engineered? Possibly!) one from scratch. This prints in two parts, held together by triangular pegs. They're oriented so you can only put it together one way. The pegs are small and tight-fitting so make sure that your tolerances are dialed in. I used a drop of superglue at each connection, but things fit so tightly, I'm not even sure if that's necessary.

Holds 3 boxes of rolled kitchen product: Cling-wrap, wax paper, parchment, foil, whatever. As you can see from my photo, it'll hold small and medium sized boxes. Those monster rolls of 400 sq ft of cling wrap won't fit. Those boxes that have an integrated sliding cutter won't fit. You might be able to scale it. I haven't bothered.

Affixed to the bottom of a kitchen cabinet shelf with permanent double-sided foam mounting tape.

I accidentally left supports turned on in the 3MF, but they aren't necessary. Brims are likely necessary for the pegs.

Read more Show less

Print spec

Formats
3mfstl
Model files
4
Total size
1.1 MB
Largest file
895.5 KB

0 comments

See all