Thùng rác / lon cứng cáp in chế độ vase mode

Thanks for choosing this model!

It is:

• Quite sturdy
• Designed to print using vase mode.
• A fast print (prints in under 2 ½  hours on a MK4).
• Remixable (with .step and .f3d files attached)
• Able to be used commercially / sold (see licence)

I printed it with 0.6mm extrusion width for external perimeters (using a 0.4mm nozzle).

To change extrusion width:

1. Make sure you are in at least “advanced” mode; this is found in the upper right hand corner of PrusaSlicer.
2. Go to print settings - advanced - extrusion width and change “External perimeters” to 0.6

Link to my old bin design:

 https://www.printables.com/model/635726-vase-mode-garbage-bin

Happy printing!

-Note-

 The original .gcode file was sliced with too high speed for the solid infill (I had to turn speed to 80% while printing the base). I plan to include a file that fixes that, but it will not be the exact same as the one i printed.