
Hộp Mồi Lửa Tên Lửa Mô Hình
- Downloads
- 28
- Likes
- 6
- Views
- 191
- Remixes
- 0
- Comments
- 0
Files 2 189.7 KB
- Launch_Ignition_Box_1766323681.stlSTL · 142.3 KB
- Box_Lid_1766323681.stlSTL · 47.4 KB
Make a variant with AI
Build another version of this model.
Details
- Model ID
- #18063
- Category
- DIY
- Published
Description
This launch ignition box is for model rockets. It prints assembled and in place with no supports. For use with one 9v battery. The case has a freely moving switch cover to protect from accidental discharge. The case has a sliding panel to ease access and change out the battery.
You will need a 9v battery, momentary switch (normally open), 9v battery clip, and a length of bell wire (or similar). The hole for the momentary switch is 7mm in diameter. Modify or drill out to accommodate for larger/smaller switch you may purchase. All parts, except the battery, should run you less than a couple dollars.
Instructions: Print with 0.3mm thickness or less. I used 0.3mm and it printed fine. Print with an infill between 15% and 25%.
The slide cover location of the main file has integrated supports so remove them prior to installing the slide cover. Installing the switch is a little tricky, but be sure to wire everything first.
ALWAYS LAUNCH MODEL ROCKETS IN A SAFE AND OPEN AREA.
HAVE FUN.
This is my original design. It is not reuploaded from another website; however, is was originally posted to Thingiverse: https://www.thingiverse.com/thing:373311
Print spec
- Formats
- stl
- Model files
- 2
- Total size
- 189.7 KB
- Largest file
- 142.3 KB
0 comments
You may also like 12 models
See all-

-

-

-

-
New -

-

-

-

-

-

-


