Pico MMU (Nâng cấp Đa Vật liệu)

                            Not recommended for beginners.

The Pico MMU is an open-source project designed to enable multi-material 3D printing on FDM printers. You can find the other STEP files on the GitHub repository

------------------------------ UPDATE ---------------------------------

NEW UPDATE (09.01.2025)

changes to the step file pcb-cover

UPDATE (29.12.2024)

New Gear-cover

New Plate ALT-1

------------------------------ Important ---------------------------------

• The Heatsink goes on the Motor driver !in the real picture its on the wrong chip!
• The Pico MMU is connected via USB or CAN BUS to the Raspberry pi (Klipper)
• You will need an (Printer) board that supports Klipper
• Marlin Firmware is not supported
• If you own a standard Ender (Marlin Firmware) 3, S1, S1 Pro, etc. , you need to flash the control board with Klipper and use a Raspberry Pi running a Klipper firmware with Mainsail or Fluidd.

4 Lane Version https://www.printables.com/model/1122273-4-lane-pico-mmu-cover-remix

Module ECAS04 M10  https://www.printables.com/model/1142481-lh-stinger-pico-mmu-with-ptfe-couplers

---------------------------------------------------------------

full Documentation https://github.com/lhndo/LH-Stinger/wiki/Pico-MMU

Step files  https://github.com/lhndo/LH-Stinger/tree/main/User_Mods/MMU

Software https://github.com/lhndo/LH-Stinger/tree/main/User_Mods/MMU/Stinger%20Pico%20MMU%20-%20%40LH/Klipper

The LH Stinger Community (Discord) https://discord.gg/NbpcZXmq9e

---------------------------------------------------------------

Credits to LH 

https://www.printables.com/@LH_511298

PCB-Cover-heatsink credits to NIX1200