
Bảng quản lý cáp USB Bambu Lab P1P với đèn LED
Remix of Bảng quản lý cáp USB cho máy in Bambu Lab P1P By 3DSourcerer
- Downloads
- 26
- Likes
- 9
- Views
- 1,221
- Remixes
- 0
- Comments
- 5
Files 2 72.9 KB
- P1P_Cable_Plate_Light_1766276050.stlSTL · 35.2 KB
- P1P_CPL_v2_1766276052.stlSTL · 37.7 KB
Make a variant with AI
Build another version of this model.
Details
- Model ID
- #1796
- Category
- Máy In 3D
- Published
- License
- Creative Commons — Attribution
Description
This is basically 3D Sourcerer's USB Cable Management Plate that I added a cut out for the bright LED from those cheap Harbor Freight flash lights you can sometimes get for free with a coupon. Pull the LED out, slide it in to the plate then attach the negative and positive leads to a USB charge cable, which I also have tons of so I just cut one in half and used it. It is MUCH brighter than the factory LED strip and really brightens up the entire inside with a super small footprint and im sure most people have a bunch of these laying around.
VERION 2 UPDATES:
Cut out some material for better clearance for the USB so I pushed the LED cut out in a little further and I cut out a little material in one of the hexagons to allow you push in a small circular on/off switch.
**NOTE** From testing on a few 5v phone chargers, 5v might be too much so you may have to also add the resistor from the flash light to dissipate some of the heat generated or you'll quickly burn the LED light since it heats it up. The resistor instead gets hot so keep that in mind when mounting. Maybe someone who is better with electronics can comment a better way to keep the LED cool using some sort of buck converter? I'm unsure of the exact voltage these would need in order to run without a resistor so if anyone knows that off hand, please comment
Print spec
- Formats
- stl
- Model files
- 2
- Total size
- 72.9 KB
- Largest file
- 37.7 KB
5 comments
You may also like 12 models
See all-

-

-
New -

-

-

-

-

-

-

-

-


