Lồng Trinh (Chastity Cage) Tự Làm Cho Nam

I didn't like any of the available 3D printable chastity cages, so I made my own. There's a few different options: a (semi) long one, and two shorter variants, one with just an open hole like the long one, and the other with a short tube part to stick into the tip of your wiener. The different variants all work with the same locking pin, ring, and connector.

These don't technically “lock” per se, but they should stay closed with the locking pin in place.

A few quirks:

-there are some thin wall, so make sure you have “detect thin walls” selected in your slicer in order to actually print said walls.

-you'll definitely need to clean up the prints during post processing to make them comfortable to wear. This mainly just means smoothing out the surface of the prints with a scraping knife or sandpaper or something (especially on the version that goes into your wiener).