Nhện Pha Lê Khớp Nối (Flexi Crystal Spider)

Hey everyone!

I’m super excited to share a brand new 3D printable design with you — an Articulated Crystal Spider. Would love to hear your thoughts about it :)

🔧 Recommended Settings:
• Infill: 15%
• Walls/Perimeters: 2–3
• Layer Height: 0.2 mm (or 0.15 mm for finer detail)
• Supports: Not required
• Brim: 3–5 mm recommended for smaller parts to improve bed adhesion

🛠 Assembly Instructions – Crystal Spider :
 

Your spider model comes in two separate files:
🔹 Spider_Body.stl
🔹 Spider_Parts.stl (includes crystals, fangs, eyes, and optional pin)
 

All parts are print-in-place friendly, but require a bit of post-print assembly. Here's what you need to know:

🕷 1. Gluing the Parts

All additional parts (crystals, fangs, eyes, etc.) are designed to be glued into the body.
Use a small amount of superglue or plastic glue. The contact points are keyed and should align clearly.

Tip: Dry-fit the pieces before applying glue to ensure correct orientation.

💎 2. Spider Back Crystal
 

This centerpiece crystal can be attached in two ways:
 

Option A – Glue it in:
Just like the other parts, you can simply glue it into place.
 

Option B – Lock it in with the pin:
Included in the parts file is a small printable pin that can be used to mechanically lock the crystal into the body.
It will require a slightly firm push to snap in — this is intentional for a tight, secure fit.

Tip: If the fit is too tight, gently sand the pin or socket for easier insertion.

🧼 Final Note:

Make sure all surfaces are clean and free of print residue before assembly. A light sanding of connection points can help with a smoother fit if needed.

⚠ Important Note:
Before printing, please make sure your build plate is clean and properly leveled. A dusty or oily surface can lead to poor adhesion — especially on the small contact points of articulated joints.

A clean bed = a successful print 🧼👌

Happy printing, and I’d love to see your finished spiders!