Máy phân phối nam châm lưới hình lục giác nhẹ hơn

Introduction

I quite liked Carl's concept of the dispenser, but even with the body printed at 0.08mm layer height the slider still caught onto the body and wasn't as smooth as I would have liked it to be.

I therefore created a version of it with these goals:

1. A hexagonal body allows for the body to be printed horizontally, making for a faster print and smoother operation
2. Reduce the gap between the magnets and the body
3. Reduce the filament consumption of the bin

Print Settings

1. Supports for the slider aren't necessary but makes sure that the magnet can sit flush. The rest don't need supports.
2. Ironing just the flat inner surface of the body can make operation smoother, though not necessary.
3. The Gridfinity bin base is designed for 0.8mm wide outer walls (which can still be done with 0.4mm nozzles)
4. The hex body has somewhat thin walls at some areas and can warp. For some reason it happened when I printed with PLA and not PETG, I probably had my cooling fan too high. The bin and clip work well with PLA.
5. PETG is recommended for the clips as PLA clips go loose after some time.

Assembly

Simply glue magnets into the 3 holes. The tabs are just there to assist with the placement of the magnet, so it doesn't matter if they break off. The cap is a bit of a tight fit by design, but shouldn't require a mallet. 

For the bin, seat the clip on the pillar such that each clip faces the corners of the base, then use a mallet to fit the clip into the base.