
Tổ Chức Cà Ri Lô Cuộn Spool SunLu 1kg và 3kg Gridfinity
- Downloads
- 278
- Likes
- 204
- Views
- 2,992
- Remixes
- 0
- Comments
- 0
Files 10 2.5 MB
- carousel_-_washer_1766673648.stlSTL · 112.6 KB
- carousel_-_stand_1766673649.stlSTL · 230.9 KB
- carousel_-_306mm_stick_1766673650.stlSTL · 97.2 KB
- carousel_-_3kg_spool_spacer_1766673651.stlSTL · 98.5 KB
Make a variant with AI
Build another version of this model.
Details
- Model ID
- #177214
- Category
- DIY
- Published
- License
- Creative Commons — Public Domain
Description
Based on Zack Freeman's gridfinity system.
Uses M3 x 8 screws for the 3kg spool design, Uses M2 x 6 screws for 1kg spool design. and gridfinity 6x2mm magnets if you choose to use magnets. Uses a 3/4inch or 20mm rod for the middle. Or you can print the provided rod design.
Printer specs: needs at least 180mm x 160mm x 100mm build volume. If you are printing the axel stick then you should have a 250mm build plate.
I have a bunch of SunLu spools lying and I wanted to use them for something. They use the older refillable spool design, I have not tested it with the newer spool design, so proceed with caution if you try to use the newer spool.
1kg spool design: Can fit 9 1x1 bases. Superglue the 1kg spacer in the middle to shrink the hole diameter. Uses M2 x 6 screws. Fits 4 spools on the 306mm stick. Use 1 washer on each end and 1 in between each spool.
3kg spool design: can fit 6 2x2 bases. Superglue the 3kg spacer in the middle to shrink the hole diameter. Uses m3 x 8 screws. Fits 2 spools on the 306mm stick. Use 1 washer on each end and 2 in between the spools.
Print spec
- Formats
- stl
- Model files
- 10
- Total size
- 2.5 MB
- Largest file
- 923.3 KB
0 comments
You may also like 12 models
See all-

-

-

-

-

-

-

-

-

-

-
New -


