
Giá đỡ giấy ăn cho hệ thống Ikea Skadis
- Downloads
- 165
- Likes
- 26
- Views
- 1,018
- Remixes
- 1
- Comments
- 2
Files 2 21.5 KB
- Skadis_PapertowelRight_1767263945.stlSTL · 10.7 KB
- Skadis_PaperTowelLeft_1767263946.stlSTL · 10.7 KB
Make a variant with AI
Build another version of this model.
Remix versions 1
See all 1 remixDetails
- Model ID
- #1760
- Category
- DIY
- Published
Description
A paper towel holder designed to fit onto the Ikea Skadis system
The brackets were designed to work with the 19mm birch rail from the Ikea NEREBY range (https://www.ikea.com/au/en/p/nereby-rail-birch-70476344/) although any 19mm dowl or rod will work
The dowel can be easily lifted up to change the paper towel and fits snuggly when in use
The design is a remix of the Skadis filament holder by Nekronomikon (https://www.thingiverse.com/thing:5543377). Its essentially the same design, just much smaller
Printing:
Print both of the files (One of the left and one of the right rails). Face cutout section where dowel fits upwards to avoid support in that area
Supports will be needed for the Skadis pegs
I printed on 25% infill but added a modifier to the peg end and increased this section to 100% like i do with all Skadis prints to ensure the small pegs don't break (See photos for modifier location)
All Files printed with our own Kobee PLA:https://kobee.com.au/pages/pla
Free shipping within Australia over $120
Happy Printing!
Print spec
- Formats
- stl
- Model files
- 2
- Total size
- 21.5 KB
- Largest file
- 10.7 KB
2 comments
You may also like 12 models
See all-
New -

-

-

-

-

-

-

-

-

-

-



