Skip to main content
F3D
Giá đỡ giấy vệ sinh hình Shaun the Sheep 1

8 images

Đồ Gia Dụng

Giá đỡ giấy vệ sinh hình Shaun the Sheep

By ptrk3d

Downloads
2,945
Likes
961
Views
25,433
Remixes
1

Files 15 27.6 MB

  • Head10.example_1766396436.stlSTL · 1.4 MB
  • FatBottomLegs_1766396437.stlSTL · 300.8 KB
  • Head7.example_1766396440.stlSTL · 1.5 MB
  • SkinnyLeg_1766396441.stlSTL · 2.5 MB

Make a variant with AI

Build another version of this model.

Open Studio

Remix versions 1

See all 1 remix

Details

Model ID
#173899
Category
Đồ Gia Dụng
Published

Description

This toilet paper holder was inspired from https://www.thingiverse.com/thing:2738946 but designed from scratch.

  1. The head was designed to look like Shaun the Sheep.
  2. The Skinny Bottom & Legs are intended for standing the toilet paper roll on the table as a decorative spare.
    • If you want to stack 3 sheep on top of each other, the bottom two can be normally placed and the top one can have it's legs swapped (right to left). This way, the top sheep will press against the body of the lower two.
  3. The Fat Bottom & Legs have a 45 degree edge that prevents the toilet paper roll from sliding off. It is useful when you intend to pull the toilet paper from it and the large base keeps it rolling in place. I printed mine in vase mode to save on material.

The OpenSCAD source code can be found here: https://github.com/glaza/gospel/tree/master/examples/ShaunTheSheep

Print Settings

  • Printer brand:

Creality

  • Printer:

Ender 3

  • Rafts:

No

  • Supports:

Yes

  • Resolution:

0.32

  • Infill:

10%

  • Filament brand:

Filaments.ca

  • Filament color:

Black

  • Filament material:

PLA

  • Notes:

I used a 0.6mm nozzle

  1. Head was printed with supports (for the mouth and ears) with 10% cuboid infill and no bottom layer since it is not visible and would be a waste of material.
  2. Mouth was hand painted
  3. Eyes were superglued on with little eye from the dollar store. They roll around as you pull the toilet paper.
  4. Skinny Bottom should be printed standing up. Please rotate 90 degrees such that the flat edge touches the build plate.
  5. Skinny Legs were printed without supports.
  6. The Fat Bottom & Legs were printed in vase mode to save on filament and print time.

Read more Show less

Print spec

Formats
stl
Model files
15
Total size
27.6 MB
Largest file
10 MB

0 comments

See all