Giá Đỡ Marker Số Cho Rallyman GT

This gear marker holder turned out quite useful, especially during solo games against several bots. The holder is made up of three parts connected by joints, which allows storing it flat in the box. It's a print-in-place model, so no assemby required.

Print the test model first:

• If the joints don't move, use x/y compensation in your slicer with -0.05 or -0.1 mm.
• Do the same, if the small pit on the back is too small for the peg. Alternatively, try sanding the peg a bit.

Also, if you are interested in box organizers for Rallyman, check out my organizer sets for GT and DIRT.