Giá Đỡ Kìm Cho Slatwall 3"

Similar in concept to the storeWall tripod plier storage stand but now you can print it yourself at a fraction of the price.

Uses the same base clip as my other Slatwall models.  For standard 3" Slatwall but has only been tested with storeWall as that is what I personally have installed.

I spent a lot of time trying to tweak the dimensions so that the parts would latch onto the Slatwall but not marr PVC Slatwall, but you should file the little latching nub down as needed to avoid any damage.  Don't force it onto your wall if you feel too much resistance.

These must be printed with supports and on their sides for strength.  If you have good build surface adhesion you can get away without a brim, but the little thin part that latches up into the slatwall has a tendency to warp and pull away from the build surface.

Get 25% off CA Filament by using the following link:  http://referrals.californiafilament.com/v4Ge58zv?smile_ref=eyJzbWlsZV9zb3VyY2UiOiJzbWlsZV91aSIsInNtaWxlX21lZGl1bSI6IiIsInNtaWxlX2NhbXBhaWduIjoicmVmZXJyYWxfcHJvZ3JhbSIsInNtaWxlX2N1c3RvbWVyX2lkIjoxMjI4MjA3NDUwfQ%3D%3D