Ốc Vặn Tay Nắp Che Khớp Nối Rivian
- Downloads
- 110
- Likes
- 32
- Views
- 588
- Remixes
- 0
- Comments
- 0
Files 4 992.5 KB
- rivian-hitch-screw_1766292416.3mf3MF · 207.7 KB
- rivian-hitch-screw-v1_1766292417.stlSTL · 447 KB
- rivian-hitch-screw-v2_1766292418.stlSTL · 218.6 KB
- rivian-hitch-washer_1766292419.stlSTL · 119.2 KB
Make a variant with AI
Build another version of this model.
Details
- Model ID
- #171073
- Category
- DIY
- Published
Description
🎁 Get $100(s) in Rivian Rewards points and 3 months free RAN charging by using my referral code TODD11893313 when 🛒 ordering a Rivian.
Description
This is a replacement thumbscrew for the hitch cover on a Rivian R1. They come with a screw that works fine but requires a quarter or screwdriver to open (or really strong fingernails). I decided to make my own take on this. You might consider buying these injection molded ones instead for greater durability, but I didn't care for the way they look.
Note: You should re-use the plastic washer that holds the original screws, but I have included a model in case you lose one.
There are now two versions:
- V1 - my original model. It feels pretty good to use but I wasn't happy with how much supports were needed and how horrible the underside looked.
- V2 - my revised model after trying to optimize for cleaner printing. Ended up with just a different design. Not sure it's any better, honestly.
Printing
If you decide to print these, you want to use a durable material. I'm using PETG because that's what I have, but TPU or ASA would be better. I spent a while trying to get the cleanest print I could, given the supports required, even though I'll almost never see these things. This ended up in resulting in the V2 version with marginal improvements. These are the settings I ended up using and what's included in the .3mf:
- Nozzle:
0.40mm - Layer Height:
0.15mm QUALITY - Perimeters:
15(so it just prints solid) - Seam position:
rear - External Perimeters first:
enable - Fill gaps:
disable - Supports:
enabled- Overhang threshold:
15 degrees - Style:
grid
- Overhang threshold:
- Print horizontally with the fins on the sides, as seen in the slicer photo.
Support
If you like my designs and want to make my day, you can buy me a ☕!
Print spec
- Formats
- 3mfstl
- Model files
- 4
- Total size
- 992.5 KB
- Largest file
- 447 KB

