Kẹp gói Doypack

I don't like it when less than half of the mayonnaise remains in the doypack package, because it is inconvenient to squeeze and store it, as it takes up a lot of space. That's why I've been looking for models to solve this problem for a long time, but I haven't found anything suitable. So I had to figure it out myself. You can see what I did. Overall, I liked what happened.

A little bit about the assembly of the structure. I may be using the wrong terms, but I do not know how to name these details correctly. So. We take the clip and the plug, they are yellow for me, and glue the plug to the end of the clip, it should enter with a little effort, this is normal. Then we insert the black rod between the clamping plugs and lubricate with glue the inner part of the hole where the axis of the rotator will be inserted. 

After that, we insert the axis of the rotator handle into the hole until it stops. That's all, actually.

A small instruction for use

They wrote in the comments that the packaging does not hold well in the groove and does not squeeze out the contents of the package well, so I decided to add instructions on how to properly fill the package into my device. I've been using it for a long time, and I don't have any problems.

First, the sachet should not be inserted into the device until it is 2/3 or 1/2 empty, preferably 2/3 empty.

Secondly, before refueling, it is necessary to squeeze out the remains in one direction, with something flat, such as a knife handle.

Third, insert the packaging into the device as shown in the photo below. And bend the edge of the package, pressing hard across the entire width so that it locks in this state.

You need to insert the packaging as shown in the photo below.

After that, you can screw the packaging into the device.

And I want to note that the contents of the package are squeezed out not due to the side rails, but due to the tight wrapping of the package.