
Hộp Chống Ẩm Kèm Bộ Nạp Dây Tóc
- Downloads
- 1
- Likes
- 0
- Views
- 92
- Remixes
- 0
- Comments
- 0
Files 8 4.8 MB
- Lid_Filament_Throughput_1766191855.objOBJ · 100.8 KB
- Overlay_Side_Filament_Feeder_1766191856.objOBJ · 85 KB
- Back_Filament_Throughput_1766191857.objOBJ · 342 KB
- Front_Filament_Throughput_1766191858.objOBJ · 116.4 KB
Make a variant with AI
Build another version of this model.
Details
- Model ID
- #168168
- Category
- Máy In 3D
- Published
- License
- Creative Commons — Attribution
- Tags
Description
A relatively airtight Drybox for hygroscopic Filaments like PC, TPU, ASA etc. Including a Filament feeder, with throughput to the printer and a window to observe the Filament status and moisture level. The box is filled with Silica Gel pouches that I have collected from purchased filaments and from other things the family has shopped (the more pouches, the better). The moisture level is normally between 20-30% in the Drybox. But the SilicaGel pouches needs to be dried, in for ex the oven at 80 Degrees C, every 2-3 months. Since I installed this DryBox its worked very well for me to print with these types of Hygroscopic Filaments.
The box itself is from Clas Ohlson in Sweden, called “Förvaringsbox SmartStore Dry”. The Throughput for the Filament to the printer is made from 3 printed parts in PLA. And then glued and screwed with M3 screws to the box. The throughput is connected to the printers filament infeed by a hard plastic tube (OD 10 mm x ID 6 mm) I had lying in the garage, probably from an old dishwasher or similar.
I also made an internal lid printed in TPU to seal the Throughput when it isn't feeding filament to the printer.
I put in a small battery driven moisture sensor (a combined hygrometer / thermometer from Clas Ohlson) to monitor the moisture level in the Drybox.
The Filament feeder is made from 3 pcs 3D printed parts in PLA, 2 pcs M6 Threaded rod, M6 Nuts and Wingnuts and 4 pcs W626 bearings. But it will probably work fairly well with printed rollers instead of bearings as well. The Overlays are glued to the sides, to prevent the sides of Filament rolls from being jammed between the side of bearing and the feeder side. The feeder is fixed to the bottom of the Drybox with double adhesive tape.
Finally I made a Window with an included holder for the Moisture sensor. It's made from 2 printed parts and a 2 mm Polycarbonate sheet. The cut-out in the box should be made very carefully since I noticed the material in it cracked very easily. I used my Dremel with a large cutting disc to cut the hole for the window. The window is glued and screwed with M3 screws to the box. There is a small groove in the window frames so all of the glue won't get squished out. The Outer window frame was also used as template for the Polycarbonate window as well as for the cut-out and drill holes in the box.
Print spec
- Formats
- obj
- Model files
- 8
- Total size
- 4.8 MB
- Largest file
- 1.7 MB
0 comments
You may also like 12 models
See all-

-

-

-

-
New -
New -

-
New -
New -

-

-


