
Chén bảo vệ giò đạp Specialized Levo Gen3 (Praxis)
- Downloads
- 0
- Likes
- 0
- Views
- 69
- Remixes
- 0
- Comments
- 0
Files 1 378 KB
- levo-praxis-crank-guard_1766177866.3mf3MF · 378 KB
Make a variant with AI
Build another version of this model.
Details
- Model ID
- #166854
- Category
- Thể Thao & Ngoài Trời
- Published
Description
This is a bash guard for the Praxis crank arms used on the Specialized Levo gen3 e-mountain bike. This model should also work on any other bike or e-bike using this particular crank-arm.
A while ago, I purchased a crank-arm bash guard online, but it proved to be ineffective against the local trail rocks. I found a similar project with a much shorter and thinner bash guard, but I wanted a stronger version which protected a larger area of the crank arms, not just the tip.
Printing recommendations
-
PLA. The walls are 2mm thick which should be plentiful for most rocks. I also tried a 3mm thick version and that should survive a direct strike from a cruise missile, so I think 2mm is enough.
-
Strength: 25% infill, gyroid, 4 wall loops.
-
Support: tree supports (for ease or removal).
-
Print orientation: As set in the 3mf file included (basically, standing on the "open" side.)
Installation
-
Remove your pedal (remember that the screw always turns towards the back of the bike to unscrew and to the front to screw, no matter which side).
-
Slide the bash guard in (logo facing outside, obviously).
-
Replace the pedal.
Note: The model fits very tightly and you may need to use a small rubber mallet or a dead-blow hammer to insert it all the way. Use the screw holes as a guide to see when it's fully seated. Do not use a metal hammer directly on the model or on the bike. If you feel it's too tight, use your slicer to resize the part to 101% or 102% and that should make it fit more easily.
Happy trails!
Print spec
- Formats
- 3mf
- Model files
- 1
- Total size
- 378 KB
- Largest file
- 378 KB
0 comments
You may also like 12 models
See all-

-
New -

-

-

-

-

-

-

-

-

-


