Dụng Cụ Nạp Tốc Độ 9mm Cho Ruger EC9S/LC9S

This is a Ruger EC9S/LC9S Speed Loader, I was inspired by https://www.thingiverse.com/thing:259940 this is not a remix but a complete redesign. I added a thumb hole at the top so that it is far easier to use.

I have added a video to show how it works

https://rumble.com/vea8zl-resin-3d-printed-ruger-ec9s-lc9s-9mm-speed-loader.html

UPDATE:

I am in the process of creating these for other guns, so I added a label to the side to identify which model it is.

Another Update:

I added the Ruger logo to the side of the loader above the model name.

Print Settings

Printer Brand:

Anycubic

Printer: 

Photon

Rafts:

No

Supports: 

No

Resolution:

.07

Infill: 

100

Filament: Matterhackers Photopolymer Orange

Notes:

I printed this on a resin printer, but I can see no reason that you can't print it on an FDM printer.. I would probably use a brim to keep it from peeling off the bed as the contact patch is very small. 0.2mm layer height would be a good setting for PLA.

NOTE:

I thought this would be obvious, but people have been commenting on the “supports”, but if you print it with the flat side of the ring on the bed (why it is designed that way), you don't need supports…  Just brim it to keep it attached… 

Category: Sport & Outdoors