Cửa Zone Mortalis 28mm (Bản Remix)

This is a remix of the double doorway with bulkhead by Eberleg found here: https://www.thingiverse.com/thing:2609112

The doors have had the aquila removed for use with Horus Heresy / 30k but are otherwise unchanged.

The double bulkhead has also been adjusted slightly to be used with Zone Mortalis terrain from a well-known UK manufacturer. The extended slots on the sides has been removed and the bottom has been made a bit thinner.

For use with Eberlegs files you can just the original bulkhead and print the doors from here.

However, to print properly for compatibility with the aforementioned products the double bulkhead needs to be scaled to about 92,5mm wide (about 91,4%), with height and thickness left alone. Note (five years later): I think I mean that the bulkhead should be non-uniformly compressed here, i.e. only scale the width, do not scale width and height at all.

The door should then be also be scaled to 91,4% wide with height and thickness unmodified. After doing this we also scaled the width and thickness (but not height) of the door another 0.5mm each to allow for painting without making the fit too tight.

Category: Games