Thùng rác hình lục giác

General

Its a fairly simple model, no supports needed. 

For extra hardware you will only need two M3-screws (8-16mm long).

Also you need to print the Trashcan lid in a specific way for the lid to close properly. 

Size

Height:        175mm

Diameter:   100mm

Printing

hex-trashcan-can

Nothing special, just print it in the provided orientation 

No supports needed

hex-trashcan-top

Nothing special, just print it in the provided orientation 

No supports needed

hex-trashcan-lid

This is the recommended print orientation

in his orientation you will need to increase your wall lines until the 45° part with the bump is printed solid -→ hex-trashcan-lid picture 2

8 wall lines should be enough for a 0.4mm nozzle