DUMMY 13 đi COMIC CON - Mass Effect - Tali Zorah Vas Normandy V1.1

29. Dec. 2023

• Improved the hand for easier printing

Based on DUMMY 13 Beta - Oct. 2023 

DUMMY 13 Printable Jointed Figure © 2023 by Lucky 13 Toys is licensed under CC BY 4.0

Get your Dummy 13 here: /model/593185

DUMMY 13 loves COMIC CON! 

So I have started to design a whole series of characters and costumes for DUMMY 13. This is another costume from the series "DUMMY13 goes to COMIC CON".

The aim is to preserve the charm and simplicity of Dummy 13.

Have fun!

Now to the content of  DUMMY Zorah, sorry Tali Zorah:

• Helmet
• Alien right hand with a M6 Carnifex (print vertically, use support and brim)
• Alien left hand
• N7 logo for the armor, even though tali does not have such a logo
• Other parts are standard parts

Print at 0.15mm layer height or less!

The STL files are already aligned as they should be printed.

Tali has a very beautiful and detailed costume and it was therefore not easy to represent her with simple colors. Just let your imagination run wild when painting her.

https://en.wikipedia.org/wiki/Tali'Zorah

Get more:

• More outfits  /@Mici/collections/967681
• More weapons /@Mici/collections/1103020
• More hands /@Mici/collections/1103017

Female Armor:

For other female body versions, have a look at my female body set → https://www.printables.com/model/637152

High-heel-booties:

https://www.printables.com/model/659695

For multicolor abdomes, look here: https://www.printables.com/model/638070

N7 Logo:

You get the best results for the logo with a 0.25 mm nozzle and 0.05 layer height. The logo is glued on the armor. 

You can use the provided 3mf file to get a multicolored version with color change from black to white and paint the last symbol red after printing. The runners can help with the positioning of the logo during application. Simply remove them carefully afterwards.

Why are there 4 logos in the file? If something goes wrong, at least one should still be usable ;)

Some inspirations

MASK:

Slide the head into the mask and press it in with gentle force on the chin.

If this is not possible, it is probably due to the following points:

•  Check the inside of the mask (the top) to see if it has been printed cleanly and remove any filament debris that is sticking out
• Has the brim been removed cleanly?
• The elephant foot can cause the inner rim to be a little too narrow, just sand the inner rim down a little or work it with a knife