
DeWalt 20V Pin Adapter Mount
- Downloads
- 125
- Likes
- 18
- Views
- 945
- Remixes
- 0
- Comments
- 0
Files 5 15.2 MB
- Dewalt_20V_Lid_6mm_Hole_1765776803.stlSTL · 517 KB
- Dewalt_20V_Lid_10mm_Hole_1765776804.stlSTL · 517 KB
- Dewalt_20V_Lid_8mm_Hole_1765776805.stlSTL · 517 KB
- Dewalt_20V_Adapter_Lid_1765776806.stpSTP · 103.4 KB
Make a variant with AI
Build another version of this model.
Details
- Model ID
- #160440
- Category
- DIY
- Published
- License
- Creative Commons — Attribution
Description
This is an adapter for DeWalt 20V batteries. I use one to power my Miniware TS101 soldering iron.
It will need two M3 heat set inserts, two m3x6mm cap screws, two of the cheap harbor freight style red spade terminals, and some wire.
The holes that accept the spade terminals are very tight. They require quite a bit of force to press in, so shouldn't require any glue. I included CAD files in case anyone wants to adjust the hole/slot sizes. I pushed them in with needle ose pliars.
It has integral supports that should snap off after the print. Obviously, print with the supports down, against the build plate.
I have included .step files, in case you need to make changes to the model.
Updated on 2/7/23 to improve printability, more material around heat set insert pockets and slightly larger spade terminal slots.
Print spec
- Formats
- stlstp
- Model files
- 5
- Total size
- 15.2 MB
- Largest file
- 13.6 MB
0 comments
You may also like 12 models
See all-

-

-

-

-

-

-

-
New -

-

-

-
New

