Đầu Lâu Trang Trí Kèm Quạ

I was looking for a nice skull with a Raven that had its wings spread but wasn't able to find one. So I used the listed models and combined them to make this one. It prints as one piece and must have support. I printed it on my Bambu Lab P1S in 4 colors. 

Print Time: 36hrs

Filaments Used:

Sunlu - Cream White PLA: Skull

Sunlu - White PLA: Teeth,  Eyes

Sunlu -  Black PLA: Raven, Eyes

Geetech - Blue PLA: Eyes

Printer settings:

Nozzle Temp: 210

Print Bed Temp: 60

Support: Auto generated Strong Tree but Normal would work as well. 

Layer height: 02

Walls loops: 2

Infill: 15%

Brim: outside only

Brim width: 10mm - Any size should be fine. I just like to make sure it stays put. 

Note: 

The feet of the Raven aren't completely touching the skull. After all the post clean up I used a lighter to heat them up a little and pressed them down.