Giá đỡ CFS cho K2 PLUS

DO NOT DISCARD THE 4 SCREWS THAT SECURE THE CFS DURING SHIPPING AS THEY WILL BE REUSED. (You can still use M4 screws if the original ones are unavailable.)

Hardware:

• 2x M3x16 screws
• 4x original CFS packing screws (or M4 screws possibly)

Print Instructions:

• BOTH PARTS FIT ON ONE PLATE
• DO NOT PRINT IN PLA (The printer heats up significantly when heating the chamber.)
• Recommended material: ABS
• Minimum: 3 walls, 25% infill
• Use supports for optimal results

Assembly:

1. Remove the 2 top screws from the back panel of the K2 Plus.
2. Using the 4 screws from the CFS packaging, hand-tighten the printed parts to the bottom of the CFS.
3. Align the back of the CFS with the back panel holes and tighten the M3 screws.
4. Secure the 4 screws holding the CFS.