Đế iPhone MagSafe có chỗ quấn cáp

A very simple yet elegant stand for the iPhone - specifically designed for the iPhone 12/13 Mini initially, but works for all MagSafe iPhones (Not sure about the new 15 Pro Max, that might be slightly too tall in vertical mode; it will work fine horizontally for the new Standby mode though!)

Print in place - no supports required. 

I wasn't a fan of many of the square cut designs out there, or stands that left the cable completely free, so I made my own with (in my opinion) a nicer appearance on the desk. 

Print Settings

• Cura 5.0 using CHEP's FF5.0_Good Profile (though layer height adjusted to 0.24mm to reduce print time)
• No supports required
• Infill 20% (just for a bit of heft; it works well at 10% but feels a bit too light)