Giá treo Lightsaber, Module

As my collection of lightsabers continues to grow I needed a way to store and display them. This is what I came up with.

It's a set of modular hangers that you can add to over time so your collection can continue to grow.

The top piece nails to the wall with a finishing nail.

I put my pieces together with a little screw and a drop of superglue. A better option would be to drive a nail for each addition. That would make the whole system more rigid.

To help grow your collection check out my modular lightsaber collection at: https://www.thingiverse.com/thing:2468440

and the first lightsaber I designed, the Lightsaber of Barda Jarrex here: https://www.thingiverse.com/thing:1230698

Print Settings

Printer:

Freaks3D

Rafts:

No

Supports:

No

Resolution:

0.2 mm

Infill:

20%

Filament:

Dikale PLA

Light Grey

Notes:

To keep sharp corners a raft or brim might be a good idea. I thought the results were fine without.

The holes where the pieces connect are just under 3mm so they should print fine without supports for most printers.

You know your printer best so be sure to slice the model in the orientation you think will work best. My suggestion is touchmark up.

Category: Props