Con lăn cuộn sợi in IKEA Samla

Remixed version of the original, 2 cm higher to accommodate more space for silica gel pearls at the bottom of the box.

Watch my video about the new version here: 

As a cheap dry storage box for filament, IKEA Samla boxes (57x39x28 cm) are used by many.

Sadly, when using a short piece of pipe to hold filaments, changing just one without disturbing the other three is very hard.

Each Samla box can hold up to 4 spools with 70mm width.
While the included filament spools from the MMU2S fit into the samla box, they are too wide so only 2 filaments fit in there.

This would mean a lot of wasted space since you now need 3x IKEA samla boxes or one huge one.

This print is the solution:

2 Filament Spools on Prusa MMU2S spools in the first Samla Box, and 3 in the 2nd one.

Print instructions

• Print 3x "spool roll bottom" and 6x "spool roll insert"
• Fit the ends of the rollers into skate bearing
• Push skate bearing assembly into place (will click into place)
• Insert M3 brass insert with soldering iron
• Connect three spool rolls into a big assembly