Đèn Lithophane Gắn Tường

Lithophane Settings added as a Text document

Assembly is just for show, so you can view the full model in 3D, DO NOT print for for use.

All parts printed at 0.12mm Layer Height.
I recommend doing atleast the roof in 0.12 and maybe add an extra permititer to avoid small gaps (I used 4).
No supports are needed on any part.

The Base has a 29mm hole to mount an E14 lamp holder and bulb. You might need to customize this depending on what youre using for a light source.

Plugs in different sizes to mount the Sides to the Base, I used the 3.4mm one, hole is 3.6mm, you need one for each side. I would print all sizes and try which one fits the best.
And dont force it and break in inside the hole like I did…

Sides are most likely going to have to be glued to the Base, only Plugs wasnt enough for me to keep it rigid so some super glue did the trick.