
Bộ chuyển đổi băng đạn Dart Zone/Adventure Force Matrixfire
- Downloads
- 445
- Likes
- 84
- Views
- 3,546
- Remixes
- 0
- Comments
- 0
Files 14 107.4 MB
- BlankFill_1765461248.stlSTL · 53 KB
- OutdatedReleaseSpring_1765461249.stlSTL · 1.6 MB
- OutdatedMagwellSpring_1765461250.stlSTL · 461.9 KB
- OutdatedMagwellElastic_1765461251.stlSTL · 741.6 KB
Make a variant with AI
Build another version of this model.
Details
- Model ID
- #157225
- Category
- Đồ Chơi
- Published
- License
- Creative Commons — Attribution
Description
Update 16May2022-Added elastic version with more clearance, extended mag release, and detailed filler piece. Step files included
Update 25Mar2022-Removed lip which could occasionally catch AF waffles
Replaces the matrixfire hopper to allow it to feed magazines. Rewire the blaster to a 2s or 3s lipo for best results. If running on 3s, I recommend adding a PWM to control the speed of the feed wheel, since on full 3s it can burn grooves in darts.
Supports: Yes, but only necessary for the “nub” hanging over the right side. The elastic version uses sacrificial bridging to create the hole which can be cleared away after the print is complete.
Hardware:
Spring version: 1x ¾" - 1 ½" screw and one appropriately sized extension spring (Captain slug style and sizing). I also used a variety pack from harbor freight.
Elastic version: 1x ¾" - 1 ½" 4-40 screw and about 4" of 3/32" elastic. Tie a knot in the end and feed it through the mag release end. Pull out through the top of the adapter, pull tight, and tie a second knot as close to the receiver as possible. Trim away excess
Print spec
- Formats
- stepstl
- Model files
- 14
- Total size
- 107.4 MB
- Largest file
- 36.5 MB
0 comments
You may also like 12 models
See all-

-

-

-

-
New -

-
New -
New -

-

-

-
New

