Đế giữ bình 8oz cho máy khắc laser XTool F1

This plate / jig holds an 8oz flask for the XTool F1 laser... (About ~ 237ml)

Note:
> You can print this plate in any filament you want.  (However, a “tough” filament is recommended)
> 15% infill , 3 walls, honeycomb pattern…

** PLEASE: **Note the direction in which this plate fits the F1 to make sure the whole 8oz flask fits with a closed shield. The “round groove” on the right hand side points outside (or towards you) while the “full open” side points to the exhaust fan inside the F1.

*********
Other plates / jigs:

Flask (back side) - 
https://www.printables.com/model/553219-xtool-f1-8oz-flask-back-side

Business card -
https://www.printables.com/model/549500-xtool-f1-business-card-plate-jig

Dual leather patch -
https://www.printables.com/model/550853-xtool-f1-leather-patch-plate-jig

4 inch round coaster -
https://www.printables.com/model/550360-xtool-f1-4-inch-round-coaster-plate-jig

**********

Like it? , please consider donating the small amount of $1 to help me with development and Design… If you own your own business and are going to use this model in your professional office / workshop / SOHO please consider donating $2 … (via: Ko-Fi ) - Thank You!

********
Looking for more XTool F1 related stuff?
Look at all my models! :)