Vỏ AirTag Chắc Chắn

This is a rugged Apple AirTag case. It is meant to be stowed inside gear or to be mounted with 3M VHB Mounting Stickers. 

It is designed to either use the included printed seal gasket, or to purchasable o-rings gaskets. 

3D Printed Gasket Seal: NinjaTek's NinjaFlex TPU

Orderable O-Ring Gaskets: Nitrile Rubber O-Rings, 39mm OD, 35mm ID, 2mm Width

The case was designed with Ingress Protection (IP) in mind, and probably rates at IP65. Note: If you submerge it in water, you can see tiny bubbles appear since 3D printing typically does  not yield waterproof layers.   

Note:

The AirTag is a perfect tight fit by design. If you need to remove the AirTag, there is a litte slot inside to insert a pin to pop it out.

Updates:

• 20250112: Added top that are a bit looser on the thread.
• 2024.01.24: Added Lanyard Loop Top

Also see the strapable remix:

Strapable Rugged AirTag Case