
Kết nối Wago 221-2411 cho 2/4/6/8 dây
- Downloads
- 151
- Likes
- 22
- Views
- 610
- Remixes
- 0
- Comments
- 0
Files 4 6.7 MB
- Wago-221-2411-Connectors_240407_1765458932.3mf3MF · 101.3 KB
- Wago-221-2411-Connectors_240407_1765458939.stlSTL · 237.4 KB
- Wago-221-2411-Connectors_240407_1765458944.stepSTEP · 1 MB
- Wago-221-2411-Connectors_240407_1765837697.f3dF3D · 5.4 MB
Make a variant with AI
Build another version of this model.
Details
- Model ID
- #155690
- Category
- DIY
- Published
- License
- Creative Commons — Attribution
Description
Hi,
a friend was in need to connect some wires for a project of his. I found the model of ‘Jemand/Joschas’ and it fitted his needs. We just needed a version for 6 wago 221-2411 clips in one piece and a base size of 52 mm x 39 mm for glueing it down. So I made this remix.
It works well in his project. I than added versions for 2/4/6/8 clips to this model to give it more usecases. There are versions with/without flaps and screw holes (3,30 mm).
I printed a few in PLA+ as also in PETG. The fit is good, no problems so far. Nothing special for the print parameters. Mine were:
- layer height: 0,3 mm
- walls: 2
- infill: 15% cubic
- 3 TOP & 3 BOT layers
The holes are designed as 3,30 mm, on my prints they turned out slightly smaller than 3 mm.
So depending on your printer calibration & the screws you wanna use you have to drill them a bit up.
Happy printing!
Print spec
- Formats
- 3mff3dstepstl
- Model files
- 4
- Total size
- 6.7 MB
- Largest file
- 5.4 MB
0 comments
You may also like 12 models
See all-
New -

-

-

-

-

-
New -

-

-

-

-


