
Bộ lọc khí cho máy in 3D CORE One sử dụng P60
- Downloads
- 133
- Likes
- 73
- Views
- 3,303
- Remixes
- 1
- Comments
- 18
Files 7 38.1 MB
- filter_adapter-mount_0.4n_0.2mm_PETG_COREONE_3h47m_1765661240.bgcodeBGCODE · 5.2 MB
- filter_adapter-canister_0.4n_0.2mm_PETG_COREONE_11h20m_1765661242.bgcodeBGCODE · 8.9 MB
- filter_adapter-funnel_0.4n_0.2mm_PETG_COREONE_10h54m_1765661243.bgcodeBGCODE · 17.9 MB
- canister_1765661236.stepSTEP · 240.2 KB
Make a variant with AI
Build another version of this model.
Remix versions 1
See all 1 remixDetails
- Model ID
- #155145
- Category
- Máy In 3D
- Published
Description
It has been my experience that HEPA/Activated Carbon filters are rather expensive. So, I was delighted to find these P60 filters (Non-affiliate Amazon US link) at a resonable cost (~$5 each). I've been using them in my house in the company's filter product and have been pretty happy with them.
Since I'm stocking them anyway, and they're relatively cheap for HEPA/Activated Carbon filters, I decided to design a canister for them I can attach to the Prusa CORE One.
This design is easily printed in 3 parts on the CORE One itself. No supports required. However, You do need to attach the “mount” and the “funnel” after printing. I tried super glue, but it was nowhere near strong enough. I suspect that something like 3DGloop will work, but I decided to weld the parts together with my 3D filament pen (non-affiliate Amazon US link).
Once the mount and funnel are welded together, you can attach it to your CORE One with 4 M3x10 screws. If you have any Prusa printers, you probably have a ton of these in your spare parts bags.
Next, place your filter on the top, and screw the canister over it. Don't over-tighten, but do compress the felt at the top and bottom of the filter a bit to prevent air from leaking through.
I printed mine with Prusament Matte PETG and thing it looks awesome! The best part is, it works great! (I don't recommend PLA, remember, PLA sags under load and, it is a thermal vent you're attaching it to).
(NOTE: I also added a photo of my draft, test print in Overture Matte White as well because it's easier to see the until in a photograph, but that version had an attempt to have a “coupling” for attaching the funnel to the mount. I didn't work, and opted for a simpler interface.)
Print spec
- Formats
- 3mfbgcodestep
- Model files
- 7
- Total size
- 38.1 MB
- Largest file
- 17.9 MB
18 comments
You may also like 12 models
See all-

-

-
New -

-

-
New -
New -

-

-
New -

-



