
Tháp cho Đội Tuần Tra Cứu Hộ với Cún con
- Downloads
- 1,042
- Likes
- 179
- Views
- 7,707
- Remixes
- 0
- Comments
- 0
Files 16 1.8 MB
- Red-Crane_1765552451.stlSTL · 114.3 KB
- Clear-Elevator_1765552459.stlSTL · 164 KB
- White-Computer_1765552465.stlSTL · 107.9 KB
- Red-Crane-Cap_1765552468.stlSTL · 22.3 KB
Make a variant with AI
Build another version of this model.
Details
- Model ID
- #155055
- Category
- Đồ Chơi
- Published
- License
- Creative Commons — Attribution
Description
I'm porting my design over from Thingiverse. You can see some makes there: https://www.thingiverse.com/thing:5146923/makes
Most of this is easy to print. A few tips:
- Legs can be laid down on their side, with a tree support for the "nub" on the end
- Print the elevator standing up with tree supports
- I tried the "tube" in vase mode, but it kept adding a bottom. So I did 0% infill with 2 layer walls, no top and bottom.
- The "crank" is printed standing up with the gear on the bottom. Enable tree supports, but put a support blocker over the top section that has a 45 degree angle.
Assembly
Assembly should be pretty straight forward. Most things have nubs, otherwise use lots of super glue. Print two "crane caps" and glue them on the very top after inserting the crank into the crane.
Crane is operated by pushing the crank slightly so the gear disengages. You can turn it to wind up a string, moving the elevator up or down. To keep it at the top, push the gear back over to it engages again.
Print spec
- Formats
- stl
- Model files
- 16
- Total size
- 1.8 MB
- Largest file
- 377.7 KB
0 comments
You may also like 12 models
See all-
New -
New -
New -
New -

-

-

-

-
New -

-

-
New

