Elemental 8 V2.1 - Loa Toàn Dải 8cm In 3D

Elemental 8 V2.1

EDIT 1: 01 / 01 / 2024

(1) Thread on Chassis is fixed

(2) Cones now have more curved edges to ease chances of breakages

(3) Chassis has hole for wires to pass through

Elemental 8 V2 is a 8cm, Full-Range speaker driver you can 3D print at home. This is not just printing a cabinet! Buying the parts needed comes in at around £15/$20 and will allow you to make 5 drivers, giving Elemental V2 a low cost of £3/$4 per driver.

Elemental 8 is the biggest of the 3 sizes. It is built to create a desktop speaker or PC Speaker build. You could also make a large bluetooth speaker to sit on a window seal or table if you would like. Elemental 8 has a higher power handling of 5W and is the loudest of the 3 designs.

Cone, Surround, Spider, Dome & Chassis are all 3D printed components. A guide is attached which goes into detail of the assembly, motor choice, amplifier and print settings, so check that out 1st!!

Want to get the parts needed? Check out my website:

https://polymate3d.com/self-sourced-motor/

Frequency Response = 70 < 16,500Hz

SPL = 72dB @ 1W/1M on Self Sourced Motor

Maximum SPL in Stereo = 85dB @ 1W/1M

Don't want to source all the parts for the motor and just want to get it direct? I offer the Entry motor which is £20 before shipping, and only has 2 motors. These motors however are +6dB more powerful. If you want the extra power, check out the link below:

https://www.ebay.co.uk/itm/255962990725

Looking for something bigger and more powerful than this!? Patreon is the place to be, using bigger and more powerful motors, which are creating more capable and HIFI quality speaker drivers. It also gets you some behind the scenes of how I design these drivers and what is involved:

https://www.patreon.com/polymate3d

Any questions, issues, ideas or troubles, please don't hesitate to contact me here or over on X / Twitter:

https://twitter.com/Polymate3D

Most of all, happy 3D printing and listening! - Paul :)