
Chân đỡ vòi sen điều chỉnh được
- Downloads
- 159
- Likes
- 33
- Views
- 572
- Remixes
- 0
- Comments
- 0
Files 9 65.6 MB
- shower_head_stand_v1.1_0.2mm_PLA_MK3S_6h55m_1765620913.gcodeGCODE · 17.4 MB
- shower_head_stand_v1.1_1765620901.3mf3MF · 1.8 MB
- shower_head_stand_v1.1_1765620902.stlSTL · 6 MB
- shower_head_stand_v1.1_1765620904.stepSTEP · 14.9 MB
Make a variant with AI
Build another version of this model.
Details
- Model ID
- #152832
- Category
- Sức Khỏe
- Published
Description
I needed to replace an old shower-head stand.
I could buy one, but what's the fun in that? :-)
Printed with PLA at 0.2mm.
No need for glue or supports.
Update 1: The screw cover was missing from the files. I've re-uploaded them.
Update 2: v1.1 minor change to the base and screw_cover, so that the cover will be less noticeable. Note that the pictures are of v1.0.
Assembly:
1. Connect the base part to the wall using 2 screws (up to 4mm diameter) with 22mm between them:
Note: You can connect to the wall after the assembly is done, but I find it a bit less convenient.
2. Use the screw cover to protect the crews:
3. Connect each printed screw to a screw-cap:
4. Orient and hold together the side parts around the shower-head holder part:
5. Use the printed screws to secure them together on both sides:
6. Slide them onto the base part:
7. Partially release the printed screws to adjust the angle of the shower-head holder.
Print spec
- Formats
- 3mfgcodestepstl
- Model files
- 9
- Total size
- 65.6 MB
- Largest file
- 17.4 MB











