
Ống đựng rác thải máy in Bambu Lab P1P/X1C
- Downloads
- 90
- Likes
- 27
- Views
- 1,305
- Remixes
- 1
- Comments
- 0
Files 3 18.4 MB
- poop_chute-chute_1766157475.stlSTL · 14.5 MB
- poop_chute-srew_nut_1766157478.stlSTL · 3.8 MB
- test_magnet_1766157480.stlSTL · 82.7 KB
Make a variant with AI
Build another version of this model.
Remix versions 1
See all 1 remixDetails
- Model ID
- #152769
- Category
- Ý Tưởng Khác
- Published
Description
Assembly:
- you need 6x3 magnets (max. 16x), I used 8 of them and works fine
- print the test_magnet file first to check if magnets will fit in to the sockets
- the chute - print with support (support is only needed in one place) and with brim (could be inner brim)
- the screw nuts - you need two of them
- put a tape on bambu back plate to secure it from sratches, etc.
- check on the picture how to put on the trash bags
The thread in the chute is M56x5.5 (metric system). The screw nuts is M59x5.5, so there is 1.5mm clearance. It's a lot but with layers of bag foil underneath it fits very well.
Print spec
- Formats
- stl
- Model files
- 3
- Total size
- 18.4 MB
- Largest file
- 14.5 MB



