Bộ sưu tập 11 nhân vật mô hình Mecca Chameleon in 3D vui nhộn
ByZED4EverLikes313Downloads5.2K
Ý Tưởng Khác
Chân Chó
- Downloads
- 479
- Likes
- 31
- Views
- 1,064
- Remixes
- 1
- Comments
- 0
Files 2 1.4 MB
- dog_paw_1766031134.f3dF3D · 365.8 KB
- dog_paw_1766031135.stlSTL · 1.1 MB
Make a variant with AI
Build another version of this model.
Remix versions 1
See all 1 remixDetails
- Model ID
- #152650
- Category
- Ý Tưởng Khác
- Published
- License
- Creative Commons — Attribution
Description
Dog Paw with hole for magnet in the back. I printed 2 and put them on my screen door so my dog wouldn't run into it anymore.
Printed at 0.2mm layer height, 15% infill, I tried printing it with and without supports, both worked fine. Added a printer pause to switch filament to get the 2 different colors.
The magnet I used was 15 mm in diameter and 2.7 mm in height, it fit in the model snuggly but I did use some superglue to make sure it wouldn't fall out.
Print spec
- Formats
- f3dstl
- Model files
- 2
- Total size
- 1.4 MB
- Largest file
- 1.1 MB
0 comments
You may also like 2 models
See all-
-
T-Slot Nuts "ITEM" linh kiện thay thế
ByBasementLABLikes888Downloads1.5K
