Skip to main content
F3D
Giá Đỡ Dụng Cụ FLsun V400 1

2 images

Ý Tưởng Khác

Giá Đỡ Dụng Cụ FLsun V400

By bjones673

Downloads
382
Likes
33
Views
1,727
Remixes
1

Files 1 107.2 KB

  • v400_tool_holder_versionB_1765462531.stlSTL · 107.2 KB

Make a variant with AI

Build another version of this model.

Open Studio

Remix versions 1

See all 1 remix

Description

I haven't seen a good tool holder for the V400, so I though I would build one. This is patterned off of several different models that were floating around for the Super Racer. It's not a remix, as it was built from scratch in SketchUp. I tried to include a bunch of different holes, slots and hangers, as everyone likes to put different things there. It can hold allot, as you can see be the one pic with mine semi-full loaded. I tried to keep this a little slimmer in terms of profile. 

I printed this with Hatchbox Black PLA, .04 nozzle on V400, using PrusaSlicer and the 3D Print Beginner V400 PLA Standard Profile (which works awsome, BTW). 

I went to 30% Gyroid fill for a little added strength (may be overkill)

No Supports Required. Should not require a brim if you first layer is good 

It took the V400 about 1 Hr and 19 minutes to print

Don't try to spread the arms into the channels from the side. Go from the top and and just give them a gentle tug to get started, then slide the holder down the channel to your desired height

Read more Show less

Print spec

Formats
stl
Model files
1
Total size
107.2 KB
Largest file
107.2 KB

0 comments

See all