Dart Zone Max Outlaw Safety Delete

Print both the left and right sides, this is installed by opening the blaster and pushing the left safety delete into the safety hole until it bottoms out. The left safety delete goes into the left side of the blaster if you were looking down the iron sights. This is the same for the right side! 

These are meant to be a tight fit, to alleviate the chance of pushing the delete back into the blaster after its been installed. 

You should print these on the face that would face outside the blaster - this will require a very small support to the tab, but this tab is not to be seen so the quality doesn't need to be perfect. 

Other mods shown:

Dart Zone Max Outlaw Replacement Frontends

Dart Zone Max Outlaw Cosmetic Plates

Dart Zone Max Outlaw Front Picatinny (and others)

Dart Zone Outlaw Replacement Cylinder

Don't have a printer? Order from OOD! Affiliate link!