Đế Gắn Ổ Cứng HDD/SSD 2.5" Tương Thích Lego

Prints well, I'm not positive on tolerances, so it doesn't “grab” perfectly onto Lego bricks, but it nestles in well and holds … alright.  I figure most folks will need to do some playing with their own filament to determine fitment.

To mount the drives, I'd recommend using 4mm long M3 screws. If you'd like to use a rubber gasket or something for vibration mitigation between the print and drive, you may need to play with the length.

Why?  Well, why not?  If you're building a server using something like a CWWK Fanless machine like this: https://www.amazon.com/dp/B0CQVJ7Q8C it would let you neatly stack your drives next to it, and even decorate them with some minifigs, or perhaps build a pc case off a LEGO Baseplate?  It struck me as funny so I designed it the other weekend, and now I'm sharing it.  Enjoy!

NOTE: The struts are 100% symmetrical, so just print the same one for both sides.  The left and right side fit neatly on a 10 stud span (8 studs between them) so the whole thing would fit perfectly on a 10x12 plate.