Pát T'EYES CC3 2k cho LC100 98-02

I made a simple bracket for mounting an oversize (11" or 13" in 2DIN) T'EYES CC3 2K headunit in the Land Cruiser 100 99-02.

You will need screws, 4x M3x10 and 4x M3x20. Screws will thread their own holes. The long screws could possibly be exchanged for wood-screws.

I have mounted it, and it looked ok. Unfortunately, I did not take any photos, as I had to dismantle it again, due to wrong cables. But so far so good.

Print Settings

Printer Brand:

Flsun

Printer: 

Flsun QQ-S

Rafts:

Doesn't Matter

Supports: 

Doesn't Matter

Filament: Clas Ohlson PETG / ABS / ASA 
 

Notes:

I used PETG, 18% infill, 3 layers top, bottom and 4 layers perimeter, 0.65mm extrusion width, 0.35mm layer height.

It needs to be solid enough to take some abuse.

PLA is not a good idea, as it will be too soft.

Use Mirror-function in slicer to get both sides of end-brackets

Update: Use flat side of updated rear-bracket towards updated end-brackets.

Category: Automotive