Kẹp Tóc Cong

My wife was looking to replace her hairpin with something a little more flexible and to her specifications. Thus, this hairpin (or hair pin) was born. Given the curves present, it prints best vertically, and therefore without supports beyond a brim. If you have a fast printer, you may want to turn the speed down a little.

I printed it vertically with PLA at 0.20mm layer height with a brim on a Neptune 4 Plus. There is only a small area that you can infill so settings don't matter as much here unless you want more flexibility.

Update: Per another's comment, printing on its side should yield more strength. The material used also matters and something stronger than PLA should last longer. I will also add that a larger layer height will give more strength as well, but a less smooth appearance so that us something to consider 

As mentioned, this does well as a printer test due to the nature of the curves, height, and distance.

Comments welcome!