
Nối Dài Chân Đế Cao Su Prusa Nhỏ Gọn
Remix of Phần Nâng Chân Đế Cao Su Cho Máy Prusa By v68AQP
- Downloads
- 20
- Likes
- 4
- Views
- 128
- Remixes
- 0
- Comments
- 0
Files 2 200.6 KB
- body_taper_small_1766156481.stlSTL · 102.8 KB
- body_cube_small_1766156481.stlSTL · 97.7 KB
Make a variant with AI
Build another version of this model.
Details
- Model ID
- #149903
- Category
- Máy In 3D
- Published
Description
Based on the food extender by v68AQP. I slimmed down the overall size of the original foot extenders while maintaining their extension height.
The original ones, especially the tapered version, were very wide. Wider than the 30mm frame on the Prusa, and is way overkill and a waste of material. Their size conflicted with much of my cable routing from OctoPrint and webcam stuff.
These are much closer to the “footprint” of the original rubber foot.
You will need the peg.stl from the original design to complete this item.
Print orientation should be correct. No supports are needed. Any infill and layer height should work just fine.
Remixed from:
https://www.prusaprinters.org/prints/52669-prusa-rubber-feet-extender
Print spec
- Formats
- stl
- Model files
- 2
- Total size
- 200.6 KB
- Largest file
- 102.8 KB
0 comments
You may also like 12 models
See all-

-
New -

-

-

-

-

-

-
New -
New -

-

