Giá đỡ sạc Xiaomi Mi Vacuum Cleaner Mini kiêm chặn cáp
- Downloads
- 107
- Likes
- 22
- Views
- 1,023
- Remixes
- 1
- Comments
- 0
Files 4 4 MB
- Mi_Vacuum_Base_v9_1765467731.stepSTEP · 1.8 MB
- Xiaomi_Mi_Vacuum_Cleaner_Mini_Wallmount_Charging_Station_1765467732.stlSTL · 2.1 MB
- Wedge_1765467733.stepSTEP · 39.1 KB
- Wedge_1765467733.stlSTL · 101.5 KB
Make a variant with AI
Build another version of this model.
Remix versions 1
See all 1 remixDetails
- Model ID
- #149267
- Category
- DIY
- Published
- License
- Creative Commons — Attribution
Description
@computer22 Raised the issue of the loose charging cable slot, and I have to say he is right.
To avoid reprinting the entire base, I made this wedge, print two, insert and press them down tight.
To remove, push them out from the back.
I want a holder that can keep my Xiaomi Mi Vacuum Cleaner Mini on the side of a shelf. I've seen some good designs, but I don't want to remove two nozzles from the main body every time.
So I made my own, which:
- Charging (using the C cable from the package)
- Print without support material.
- Easy installation, no need to pre-drive two screws into the wall and hope they are aligned.
- Can sit on the table.
Installation:
You will need two #8 flat head screws;
Screw the first one into the mounting surface;
Slid in the bottom hole on the back of the printed charging station;
Adjust the angle until it is perpendicular to the ground;
Drive in the other screw from the front.
Wa-lah!
Print spec
- Formats
- stepstl
- Model files
- 4
- Total size
- 4 MB
- Largest file
- 2.1 MB


