Skip to main content
F3D
Hộp Đựng Pinecil Omnifixo 1
Hộp Đựng Pinecil Omnifixo 1
1 / 5

5 images

DIY

Hộp Đựng Pinecil Omnifixo

By PosterBored

Downloads
630
Likes
220
Views
10,303
Remixes
2
Download all (.zip)· 3 files · 10.6 MB· 10.6 MB

Files 3 10.6 MB

  • Omnifixo-Pinecil-Case_0.6n_0.3mm_PETG_MK3S_4h20m_1766210407.gcodeGCODE · 7.9 MB
  • Omnifixo_Pinecil_Case_1766210405.stlSTL · 2.2 MB
  • Omnifixo_Pinecil_Case_1766210406.stepSTEP · 498.7 KB

Make a variant with AI

Build another version of this model.

Open Studio

Remix versions 2

See all 2 remixes

Details

Model ID
#148876
Category
DIY
Published

Description

My Omnifixo needed a cool field kit too, but I don't own a TS80P, I own a Pinecil. There's room for improvement, but I'm pleased with it. The plate is best slid on from the side so the magnetic clamp bases don't shoot out and stick to it. The plate is fully flush with the edge when in place on top. Stays on nice and tight, the lid doesn't come off even if turned upside down and shaken.

This was printed with a .6mm nozzle at .3 layer height, in PETG. The 3 magnets are 3mm(2.65~)x8mm.

Read more Show less

Print spec

Formats
gcodestepstl
Model files
3
Total size
10.6 MB
Largest file
7.9 MB

0 comments

See all

F3D uses essential cookies so the site works. Accept all also turns on marketing cookies for traffic and ad measurement; Essential only does not. You can change this in Cookie settings. Read the cookie policy